temperature

The separator is suitable for operation in the environment of 0 ~ 40 degrees Celsius, if the product needs to be used in the above temperature standards

For external operation, please follow the instructions below:

1.20 ~ 0C: The viscosity of lubricating oil at low temperature will be higher than that at normal temperature, so that the revolution can not be increased. Therefore, please use lubricating oil with a lower viscosity than recommended.

2.40 ~ 70℃ : At high temperature, the viscosity of the lubricating oil will decrease than that at normal temperature, resulting in decreased lubrication performance and accelerated wear of the internal parts. Therefore, please use oil with a higher viscosity than recommended.

3.70 ~ 100℃ : Standard seals are not suitable for use at this temperature. High-temperature seals need to be replaced. Please indicate this in advance if necessary.

humidness

Humidity Humidity in the air can cause rust on the surface of the product. Therefore, in an environment prone to rust, the installation base surface needs to be coated with butter or anti-rust oil; The machining surface and inlet/output shaft other than the installation surface shall be painted for protection or other types of anti-rust treatment.

Electric current

When the current passes through the input/output shaft, the spark generated by the contact between the rotating body will cause slight corrosion on the surface of the rotating body, resulting in the output shaft and the ball groove in the CAM drive. This phenomenon is called electrical erosion. Even at a current of less than 1 volt, a surge in current can cause erosion. So if the product has. Chance contact current, make sure it is insulated. Long-term electrical corrosion will lead to the increase of vibration and working noise of the internal transmission parts of the product, and will accelerate the shortening of its service life. When connecting the motor, try to use rubber couplings with high insulation. The use of rubber V-belt, synchronous belt, etc. can also effectively prevent the occurrence of electrical corrosion.

dirt

Generally, the air dust in the work shop will not pose a problem to the use of the product. What impact. However, if the air quality of the environment is too poor, dust and other substances in the air will accelerate the aging of the seals and lead to oil leakage. Therefore, if the working environment is too dusty, it is recommended to use plastic or stainless steel protection to achieve dust protection, but be careful not to affect the heat dissipation.